3 replies
by toolman2010
It may not be the most complete answer:
Something you may already know -
Port numbers that tunnels use:
1. PPTP VPN uses TCP Port 1723, IP Protocol 47 (GRE)
2. L2TP: UDP Port 1701
3. IPSec: UDP Port 500, Pass IP protocol 50 and 51
Note: 47 is a protocol number and not TCP port. The protocol name is GRE.
The following example is a simple PPTP access list:
access-list 110 permit tcp any host x.x.x.x eq 1723
access-list 110 permit gre any host x.x.x.x
The first line opens port 1723 and the second line opens for the gre protocol.
This access list would then be applied to the interface where the XP client
is connected to the router. You can make this more secure by being more specific
and changing the 'any' to the IP address of the XP client or changing it to the
network reference where the XP client is.
Example of very specific access list.
access-list 110 permit tcp host z.z.z.z host x.x.x.x eq 1723
access-list 110 permit gre host z.z.z.z host x.x.x.x
This is just the tunnel access part of the changes that you would need to add. Also remember to construct your access-lists so that you don't deny all traffic when you apply it to the interface. You can apply it to an interface with the following lines:
Router(config)#interface Ethernet 1
Router(config-if)#ip access-group 110 out
by wmcmillin
by psmithersvt
This discussion is closed to new replies.
Trending IT Employment posts
Sort by Trending