Discussion Locked

Clients w/ new IP's unable to see PDC

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Okay all-

I have an NT4 server with Exchange 5.5, clients of 95 and 98 access it.

We had a base of IP's, say 111.111.26.64-128. From ISP, we needed another block of 64, they gave us 111.111.226.1-63. Netmask for all is 255.255.255.0

<<*not the real Ip's, but the 3rd and 4th portions are what we have... =)>>

All machines with the old block access the network, internet, and exchange fine.

Any machine I try to give the new IP to will not log onto the network/Exchange but can access the internet- new block was added to the firewall.

I know about NT not liking different subnets, but is there a fix to this- or do I need a complete 128 set? I've just finished getting all switched to this new set and really don't want to have to visit each machine again.

We utilize alot of outside DB that use the IP's as part of the authentication, so DHCP is really not an option.

THANKS!!

Ideas- please?

14 replies

by aekland

Answer one will work as long as you do not want to hit any other systems outside of your network that have 111.111. You could switch to a private address if your firewall supports nat. You should check the routes on the firewall and any routers. With the 255.255.255.0 mask the computers on the new ip set will look for the gateway to connect them to the original set.

by gregc

Dual home the NT Server, that is put 2 nic cards in it. The other answer is to create a loopback adapter and put anIP address of the new Subnet on the Loopback adapter. If you dual home you could then make the NT Server a router to route in betweenthe Subnets. Lots of ways around this problem including using Private IP's and NAT, just depends how you want to do it!!!

Hope this helps you out!

Greg

by enserng

Didn't need two NIC's... the advanced tab on NT server let me add a second IP to the NT4 server.

by enserng

I am not ignoring replies- I have to wait til I can get downtime to switch the subnets and try the first suggestion out!

More to come asap.

THNX

by tgotschall

If I understand your question correctly, you can simply go into the advanced tab of your protocol config on the server and add a second IP from your new lot of addresses. This should allow access without adding any hardware.

by kevinknaul

I agree with the subnet mask as you may need a 255.255.*.* however, another answer could lie within your routers. If you have routers you need to setup an interface on each network, which will allow the two networks (IP Ranges) to communicate with each other. IF you don't have routers, I recommend you get some, but if not you need the 2 NICs. Hope this helps....

by burcjo

Answer 4 is correct. The reason why you can't access your internal network resources(email, etc) is because those internal machines think your new block of ip's resides OUTSIDE of your local network. Placing the second IP address on one of your servers, that is within your new block, will "localize" that block of ip's.

If you have access to the device that is your default gateway, that is the best location to add that secondary address.

This discussion is closed to new replies.