Discussion Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
TRIED TO CHANGE PROSSER AND WHEN POWERED UP, GOT AN ERROR MESSAGE CMOS RAM HAD BEEN CLEARED AND TO SHUT DOWN. PLEASE HELP ME GET BACK UP AGAIN!! I HAVE TO USE MY COMPUTER A LOT. THANK'S KENNY
4 replies
by scott.heath
It sounds like you may have accidentally pulled the jumper that clears the CMOS. You need to consult your PC or Motherboard manual and put it back on in the correct place. Let me know if you have any questions.
by kenny5763
Poster rated this answer
by thechas
I suspect that your CMOS back-up battery is weak.
The full shut down to change the CPU may have been enough to drain the battery to the point where the CMOS was reset.
Check / replace the battery.
Boot up again, and enter setup.
Adjust the BIOS settings as needed.
CPU clock speed,
RAM speed,
Date and time,
Drive types and boot order,
Port settings, printer port in particular
Power management
Save settings and exit setup.
The system should boot up and be okay.
Chas
by kenny5763
Poster rated this answer
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
20 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
14 replies