Discussion Locked

Compaq 6500 / Win2K / Hotswap Drives

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Good day,

I have a Compaq Proliant 6500 PPro/200 with 2 processors with Windows 2000 installed. There is not an Array card installed, I am using Windows software raid at the moment.

My question is what is necessary to shutdown a harddrive to enable me to remove it while the server is running (i.e. hotswap). Now, I know you can do this with the PCI cards, but how do you do it with the drives? Is this option only avalible with the Array card? I have tried disabling the drive, and removing the drive in the hardware device list. Neither worked.

Thanks

Tony

8 replies

by mmiller

Unfortunately, without the array controller you can't hot swap the drives. The on-board SCSI controller doesn't support disabling and re-enabling the drives dynamically. If you are using software RAID 1 (mirroring), you could remove a drive; but youwould need to reset the box to add the drive back to the system.

by fataugie

Thanks, I had a feeling it was something the array provided in the way of a utility.

Tony

by sfo farmer

Tony- Invest in a Compaq Smart Array- it's the best way to go. The array controller is the "brains" to rebuild (after a hot swap)or an expansion. If you are using NT mirroring take a look at the MS NT server resource kit supplement4- it contains a GUI utility called FTEdit (Fault Tolerant Editor) that may make it easier when you break the set.

Good Luck- SFO

by fataugie

Thanks, MMiller stated the same thing earlier. I will look into the FTEdit however.

Tony

by aekland

The hot swap capability is part of the scsi back plane. The array controller handles any errors from the loss of the drive and the auto rebuild. I haven't tried swapping a drive on a non array Raid set on 2k but did some testing in nt4. I do not remeber the exact outcome but the hot swap worked. One question would be why are you swapping the drive? If it is failed, just pull it and plug in the new one. I have not messed with 2k enough to know how easy the raid recovery is but it will recognize the new drive. You may need to reboot to repair the raid. If it is active I do not know how to shutdown the drive, I have only had need to pull an active drive on array controllers, however you can pull it and let it spin down in the cage. This may cause problems because of writes or reads at that moment. If it is the primary mirror this will probably make the computer fail or reboot, otherwise the computer should be fine and it will treat it as a failed drive.

by aekland

BTW answer 2 is the best for any large raid set (more than a mirror or stripe set), with the cache and the increased power you will get a much better performance increase than adding drives to a software raid set.

by fataugie

Thanks, but the drive instructions state that you shouldn't remove a hotswap drive unless the light is amber, not green. There is no way I can find to put the drive into the "amber" state. It must be something that the array provides in the way of a utility. BTW, I was trying to find out before I had a problem under W2K, not in the heat of the moment!

Thanks though

Tony

This discussion is closed to new replies.