Question Locked

computer wont send monitor signal

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Im using amd 1.6ghz board with radeon 9200 video card my monitor will stay on standby when i start my computer i get 1 beep fans lights cd drives, hdd ect. are all working

9 replies

by thumbsup2

It could be the monitor itself or it could be the video card. Test using a different, known to be good, monitor. If the different monitor works, it's the old monitor gone south. If the different monitor does not work, it's the video card.

by oh smeg

If it has not worked it is most likely a Chip Set incompatibility between the Video Card and M'Board Chip Sets.

When this happens the fans keep running but you get no response for the M'Board or Monitor.

Or if this has been working previously what has happened recently? I do agree to test this monitor on another computer or use another monitor with this computer but it is also possible that the PS has lost one or more of it's critical Circuits.

So there are effectively 3 possibilities here the Monitor has died and gone to Silicon Heaven, The Video Card has carked it and gone to Silicon Heaven or the Power Supply has failed in some form and gone to Silicon Heaven.

Does the Monitor get any display at all?

If you disconnect the monitor from the Video Card do you get a message that it is not connected?

I saw one case where a PS had died but the fans ran the only real give away was that the Monitor showed a Disconnected Signal when you turned the power to the Case on. When you turned it off the monitor behaved normally.

In that case the owner bought new M'Board, Video Card, CPU, RAM and Video Capture Card. They bought these one at a time and replaced as they bought them then brought it in complaining that neither the old or new parts worked. When I changed the Power Supply both the old & new parts worked. But they did save themselves the cost of me fitting the new parts except for the Power Supply. :D

Col

by kameronroxursox5

And they both worked on that board but now not either one will work and i tryed 2 diffrent monitors so idk what now

by thumbsup2

The type of beep you're receiving is an indication of the problem. So, tell us if it's a short beep or a long beep?

Also, are you absolutely sure you've plugged the card into the right slot and it's snapped down into place?

by oh smeg

I think you'll find that it works after you plug one in and most likely both Video Cards will work as well.

Col

by kameronroxursox5

Now when i start it up it has no image on screen and gives loud ass long beeps and there spaced like 5 seconds so like beeeep beeeeep

by oh smeg

Here is a link to the BIOS Beep Codes. These are a error message telling you what is wrong here. If the other PS worked what made this one different?

And since You Know that the Other Power Supply works have you thought to test it in another computer?

http://www.biosman.com/bios_support.html

This discussion is closed to new replies.