Discussion Locked

Conecting to remote server on Wan whilst

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello

I'm have a serious problem, whilst dialled up to the internet, i cannot conect to remote servers on the wan, when connected to the internet the isp dns address is the default and i cannot ping
anything on the wan.

does anyone have anyideas im using a Win 2000 pro system.

thanks

5 replies

by quintar51

Go into the dial up connection properties, Networking tab, TCP/IP, Advanced, DNS tab.

Add your internal DNS server to this list, make it the first one, then add the ISP's DNS server.

by craig it mangaer

You have a couple of choices. First thing you need to do is make sure that your routing table is setup properly. You could even use the LMHOSTS file if necessary or a WINS server. If you have an internal DNS server you do want to make sure that is setup on your dialup connection. If you connect through the dialup at alternate locations you will need to make sure the ISP's DNS information is also listed. You can also use the route add command to make sure that your PC knows about the other subnets on your WAN, if you do not have an internal DNS server. (make sure you make the route add persistent -P so that they are added automatically on reboot).

This discussion is closed to new replies.