Discussion Locked

Configure Exchange 5.5 For Sub-Domains

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How do I setup a subdomain on Exchange 5.5?

Example: Right now exchange is installed on Server1 so email is going through this server. I also have Server2 with Sendmail. How do I configure exchange so that email for john@server2.mycomp.com will be pointed correctly to Server2, where John will use POP to retrieve his mail? Without any subdomain configuration, Server1 seems to get confused and just bounces the message back to the sender.

Advice and instructions would be gladly appreciated.

Thank you.

3 replies

by mmccaskill69

To configure SMTP relay for domains and subdomains, use the following steps:
1. Open Internet Mail Service properties.
2. On the Connection tab, click E-Mail Domain, and then click Add.
3. In the E-mail Domain field, type the namespace for the domain to be
relayed.
NOTE: By default, all subdomains are also relayed.
4. Click "Forward all messages for this domain to host", type the fully
qualified domain name (FQDN) or the Internet Protocol (IP) address of the
target host, and then click OK.
5. On the Routing tab, click "Reroute incoming SMTP mail", and then click
Add.
6. In the "E-Mail sent to this domain" field, type the namespace for the
domain that needs to be relayed.
7. Click "Override relay restrictions. Always relay.", and then click OK.
8. Restart Internet Mail Service when you are prompted to do so.

This discussion is closed to new replies.