To configure telnet from the inside do the following from a console connection to the PIX. (Stay away from the PDM, command line is best)
From privledged mode you will enter global configuration mode by typing the following.
We will assume the inside interface is on the 10.10.10.0/24 network.
PIX# configure terminal
PIX#
The command for telnet access is
PIX# telnet 10.10.10.0 255.255.255.0 inside
Additionally you will need to set the password for telneting to the PIX. You do this with the PASSWD command.
PIX# PASSWD yourpassword
Question 2.The PIX out of the BOX is not configured to pass traffic. Once you hace set the internal and external addresses, activated the Interfaces (adminstratively down by default) and configured a default route, you activate NAT or PAT.
There are several configurations you can use, static one to one NAT translations, Global NAT pools and PAT. For the purposes of this explanation we will use PAT. A private addresses is in my example, but your assigned registered IP address that you want your clients to use would be substituted here.
PIX# global (outside) 1 10.10.10.5
10.10.10.5 (your registered IP here) would be Port Address Translated for your inside hosts. Alternatively if you had only one IP address and were running PIX IOS 6.2 or above you could use this command.
PIX#global (outside) 1 interface
This would cause the IP address assigned to your outside interface to provide a PAT address for your clients.
Almost done. Now you must specify your inside hosts to use NAT when surfing the web. This is accomplished with the NAT (inside) command.
PIX#nat (inside) 1 0 0
This will allow all inside hosts to surf the web.
Hope this helped
Chris Weber CCDP