Discussion Locked

Configuring a Pix for VPN with IAS

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to configure a pix firewall to authenticate a VPN client to a RADIUS server. The Radius server is MS IAS.

The event logs on the server tell me the user was authenticated. The problem is the client is getting an error message stating"the connection has timed out waiting for a valid response from the server".

On my radius server I have the inside interface of the PIX configured as the client. The VPN client connects to the outside interface. The client is getting authenticated but the pix is not getting the response it is expecting.

When I tried setting the client up as the outside interface I got a message stating the request came from an invalid ip address.

Has anyone configure a pix with Microsofts Radius server in this configuration? Any suggestion is appreciated. I have contacted Microsoft and Cisco to no avail.

Thanks,
Dave

1 reply

by Member 20071246

Use Cisco Secure Access COntrol Server (Cisco ACS) for this scenario. It works perfectly.

For IAS: Check the attributes in the IAS server under Radius server properties. The Radius server parameters should not be: Generic Radius or IETF but Cisco. There is a drop down that lets to choose the radius parameters in a granular fashion. Cisco should respond to the Cisco Radius handshake values passed on by the Microsoft IAS server. Check the shared secrets, check for closed ports on PIX (You will have to open up 1812 and 1813 for this). Configure a client (normal Win98 dial up) and attach a modem to the AUX port of a router. Use the IAS server for authentication:

aaa new-model
aaa authentication login default radius local

Configure the radius-server host and radius-server key. Try this first. If the client is authenticated, perhaps PIX could be the problem maker.

Thanks,
Rookie

This discussion is closed to new replies.