Discussion Locked

Configuring DHCP on 2950 CISCO Switch with 2 VLANS

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi guys...

I have 2 VLANs configured on a 2950 CISCO Switch (VLAN2 and VLAN3). I would like to configure DHCP on my Switch releasing IP addresses from saperate address pools for hosts coming up on both Vlans. Is there a solution other than the Microsoft DHCP Server.

4 replies

by faradhi

I dont know if the switch will act as a dhcp server.

If you just want DHCP then you can use a desktop computer since there is not a need for that much power. Then install a distribution of linux and set it up as a dhcp server. Put one on each vlan.

This is cheap and fairly simple to implement.

by imtiaz.uddin

1.No need to install any other devise, just configure 2 vlans in the switch-Vlan2 & Vlan 3.
2.Create two dhcp pools in the cisco switch with 2 different subnets as per your requirement.
3.Place the ports belonging to appropriate vlan.
3.Device in the vlan 2 will get ip from vlan 2 dhcp pool, and device in vlan 3 will get ip from the vlan 3 dhcp pool.

If you need detailed configuration or step by step configuration you can send me an email on imtiaz.uddin@rediffmail.com. i'll reply you.

This discussion is closed to new replies.