Discussion Locked

Conflicts on my IRQ on Windows 98SE

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed 2 USB ports onto my computer (through a PCI card to enable use of a Web cam and Digital camera as my computer is alittle old and had no USB ports).Now I have a conflict against my Com Ports 1 and 2. The conflict is within IRQ 3 and 4. I have gone into Device manager etc and tried to manually change my USB settings from the conflict 3 and 4 to an available number but it is not allowing me to do this. Every time I try it comes up with the message 'Unable to modify setting'Is there a way of manually doing this? My free available IRQ numbers are 10 and 16 so when and if I am able to change this would these be good numbers to change to? Please help

1 reply

by thechas

Start by checking the USB card to see if it has IRQ jumpers. You may need to set them to the IRQ you desire.

Next, remove the USB ports from device manager.
Shut down.
Move the USB card to a different slot on your motherboard.
Boot up, and enter BIOS setup.
On the Plug and Play device or resource management screen there should be an option to update ESCD. Change the setting to yes.
Save and exit BIOS setup.
The USB ports should now install using a different IRQ.
Unless a conflict occurs, there is no problem with devices sharing IRQs.

1 more thought, are you using your serial ports?
If not, remove them from device manager and disable them in BIOS settings.

Chas

This discussion is closed to new replies.