Discussion Locked

data error reading drive c:

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had a power outage and when I went to restart my computer I got a message that says error reading drive c: I put the boot disk in to try to restart that way and it bring my to the dos prompt. I than tried to boot from the cd and nothing. can someone help me solve this problem. I'm using win 98.

thanks

9 replies

by darts32

Is your HD being detected at startup. Its possible that the power outage has crashed your HD. Try to go in the bios and have it detect your HD.

by thechas

The W98 CD is not a bootable CD.

When you boot from the startup floppy, can you browse the hard drive?

Use C: and enter to switch to the C: drive.
Use CD and the folder name to change directories.
Use dir /p or /w to view the file list in a directory.

How about the CD drive?
Can you browse to it?

If you can browse to both drives, you may just need to re-install W98 to repair a damaged cluster on the hard drive.

If you cannot browse either drive, you may have a bad drive or motherboard.

The easiest way to check, is to try the drive in another PC.

Chas

by johngreer

Can you see C: after you boot from A: ?

Have you tried running FDISK, to see if it can see the HDD, or even better CHKDSK C: ?

by fred07

From your start boot disk at prompt type, scandisk C: and let it fix itself. If pc was on at outage it may have screwed up a link or two and hopefuly scandisk will fix it.

This discussion is closed to new replies.