Discussion Locked

DHCP range full

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My DHCP range is full class C,I need to connect antoher network with 100 machines from class c ip address with different network id.how to configure NT so that both the networks will communicate with each other.

4 replies

by ericd173

Are they workgroups or domains?

If workgroups, just use the same subnet in both ranges.

If they are domains, you will need to setup a 2-way trust between them.

by curlergirl

You need to use a different subnet for the second network and routers between the networks so that they can communicate. For example:

Network A - 192.168.1.x subnet 255.255.255.0, default gateway 192.168.1.1
Network B - 192.168.2.x subnet 255.255.255.0, default gateway 192.168.2.1

Router A - 192.168.1.1
Router B - 192.168.2.1

Routers need to be connected to each other through Ethernet switch/hub or broadband connection.

DHCP server in Network A has scope of 192.168.1.1-254
DHCP server in Network B has scope of 192.168.2.1-254

If your routers are also connecting to the Internet, you will need to give them a static route for the other network in order for them to correctly route between the networks and out to the Internet.

Hope this helps!

by rabbit_runner

Here is another idea. Since you are using a Class "C" network, your mask is 255.255.255.0

I am assuming that your IP range is 192.168.1.xxx and 192.168.2.xxx

Simply change your subnet mask to 255.255.252.0

This will allow both subnets to be on the same network. Since you are using DHCP, simply change your scope to show the new IP settings and mask.

Suggestion, I would do this over a weekend, because doing it during the week will cause workstations not to connect to the network.You will need to have all users shut down their workstations for the weekend, then change the subnet mask for all of your servers, routers, and network printers (your servers have static IP's, Right?) Then change your DHCP settings for the new subnet. Then when the users come in on Monday, they will receive a new IP with the new settings.

This will allow your networks to communicate directly.

Hope this helps.

by rabbit_runner

NOTE: you will be able to use the IP addresses between 192.168.0.xxx and 192.168.3.xxx

The third octed will increment in units of 4. Therefore if you use 192.168.4.xxx, you will have a range up to 192.168.7.xxx

This discussion is closed to new replies.