Discussion Locked

Dial-on demand and email dequeueing

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've setup an Exchange Server with dial-on demand connection from the LAN to the Internet. The email server remains switched off during after office hours, becuase of power problems, etc..

To make sure all incoming emails are dequeued from the ISP's secondary mail server, a third party utility 'dequeue.exe' has been configured to retrieve emails every half an hour. This was working fine until a few weeks back till the ISP changed some settings of their mail server.

Currently while using 'dequeue.exe' it reports 'Unrecognised command' for the switch options specified for dequeue, even tried manually connecting using telnet to port 25 and issuing the 'ehlo' and 'etrn' commands, still give the message 'Unrecognised command'.

I do notwant to use the dial-up networking option and ETRN within Microsoft Exchange.

Any idea why this is happening? Any other alternative methods exist?

Help appreciated.

Thanks in advance.

3 replies

by mckaytech

If you can't even get to the mail server with a manual SMTP command, you're going to have to take it up with your ISP. I suspect that they have made some major changes to their server (perhaps it's only accessible by POP3 now? or new IP address?).
I think your only alternative is going to be a POP3 dialup of some type. Microsoft supplies a POP3 connector for Exchange when it's part of a Small Business Server.

paul

by sharad sreedharan

Thanks Paul

I did take up this issue with the ISP and it appears that they have setup firewall as part of their change in policy, etc.. Customers are never informed of the changes!! Strange it is sometimes!!

So, currently it's only PUSH, PULL does not work!!

We live at the mercy of the ISP!!

This discussion is closed to new replies.