Discussion Locked

Directory Catalogue and Domino R5

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to set up directory catalogues,
so that clients can look up e-mail
addresses commonly used in the
company from the server, although these
users are not in the domino domain.

However, when I follow the instructions
from support.lotus.com, and load the
dircat task on the server, it attempts to
start, and then shut down again
immediately. If I load the dircat service
without specifying which directory
catalogue file to load, the service starts,
but it doesn't actually show up the
external address books in the address
dialog in Notes.

However, if I look in People and Groups in
Domino Administrator, both the Domino
Directory, and the directory Catalogues
are listed there.

Any ideas?

3 replies

by vtrip

Hi, I am sure these step-by-step intructions will help you:
1.Prepare a server to build the source directory catalog.
2.Set up the source directory catalog.
3.Build the source directory catalog.
4.Do one of the following:
If you configured the directory catalog for server use, set up the directory catalog on servers.
If you configured the directory catalog for mobile use, set up the directory catalog on Notes clients.
5.(Recommended) Set up directory assistance. Note that it's not necessary for directory assistance and a directory catalog to have the same secondary Domino directories configured.
Basically, To create a directory catalog, you create a source directory catalog database using the template DIRCAT5.NTF. Then you create a configuration document in this database in which you specify the file names of directories to combine in the catalog, the fields to include, and other configuration options. The server that stores the source directory catalog typically stores all replicas of the directories combined in the catalog.
After configuring the source directory catalog, you run the Directory Cataloger, the Dircat task, on the server that stores the source directory catalog.

This discussion is closed to new replies.