8 replies
by whitehaat Accepted solution
by Former member Accepted solution
Get hold of another hdd and replace this inside your case, get hold of a hdd external case/caddy and put the old drive in this. Load up your Windows software and download all the updates etc then connect the external drive to your computer and (if you are lucky) transfer your files over to your new drive.
Please post back if you have any more problems or questions.
by 1bn0 Accepted solution
by jblack Accepted solution
You ought to go download a drive check utility and scan the drive to make sure there isn't a problem with it. Seagate has a good utility at http://www.seagate.com/www/en-us/support/downloads/seatools/ .
If the drive checks out fine, I'd check out the Master Boot Record corruption link above.
by nepenthe0 Accepted solution
Intrigued with your suggestion, I downloaded the Seagate utility and ran the software. It doesn't recognize my WD SATA-II 320GB HD.
Do you have a [i]Plan [b]B[/b][/i]?
Rick/Portland, OR
by jblack Accepted solution
by ic-it Accepted solution
Would be to use an XP CD to try and do a chkdsk /r repeat until no more errors are found.
Hard drive is still on the Boot options so it should not be totally gone.
If chkdsk can't repair it, then either UBCD or simply MHDD32. Set it to loop and repair, run it through at least three times unless no errors are found.
Should chkdsk help, then try to boot. Same message, Recovery console bootcfg /list, perhaps a bootcfg /rebuild, or fixboot, and/or fixmbr.
Still no go try a repair install.
by nepenthe0 Accepted solution
Curiously, WD is aggressively promoting its new [i]VelociRaptor[/i] 320GB 10,000rpm 16MB cache SATA-II HD, but the WD utility has not been updated for SATA-II.
I was curious about this post, because I plan to replace my current WD 320GB 7,200rpm 8MB cache HD with the new [i]VelociRaptor[/i] drive when [i]VelociRaptor[/i] becomes available later this month.
Alas, I'll be compelled to translate the technogeek packaged with the drive. At least you folks speak English...
Thanks.
Rick/Portland, OR
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending