Well, according to Microsoft KB article you can set up a message using a command line, but you can't actually run it in a batch file. You CAN use it in a desktop shorcut, for instance.
"In order to create a preformatted and preaddressed email message it is necessary to build a command line string with the following parameters:
mailto:?cc=&bcc=&subject=&body=
Where the following variable definitions apply:
Variable Field Entry
--------------------------------------------------------------
e-mail address to appear in the To field
e-mail address to appear in the CC field
e-mail address to appear in the BCC field
text to appear in the Subject field
text to appear in the Body of the message
Note the position of the question mark and ampersand characters in the command line syntax.
In addition to the field designations, you must use ASCII hexadecimal equivalents as variables for punctuation characters. The following variables are used to represent commonly used characters:
Space ( ) %20 Comma (,) %2C
Question Mark (?) %3F
Period (.) %2E
Exclamation Point (!) %21
Colon (:) %3A
Semicolon (;) %3B
(NOTE: I found this not to be necessary w/OL97 and 2K).
This command line string may be used in the following implementations:
In the Open box of the Start, Run command line.
In Properties of a Desktop shortcut.
In the Address Bar of Internet Explorer 4.0.
In the body ofan Outlook Express e-mail message.
In the HTML code of a Web page."