Discussion Locked

DSL Cable on network

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Does anyone have any idea on how a cable router can work on a network? The router is connected to a nic on the server and the server has internet access. The other nic is connected to a hub and works for the internal network. The problem is the internal network can't see the other nic for internet access.

3 replies

by radiic

Microsoft Proxy Server. I assume that your server is NT. I believe that you can only buy ISA now> that is the new version of MPS. The reason why your internal network cannot see the other nic to get out to the I-Net is that it is a total differentNetwork. Address.

You can even run some gateway software if you dont want to make your server there a proxy. But you need somthing to run some NAT there for you. If you were lucky enough to allready have a Linux box there you can use that to do the job too.

Have fun.
Rad

by ebob

Assuming Windoze of some sort...

Do you really have a cable "router", or a cable "modem"? Your cable supplier delivered a "modem". If you actually have a "router" then either it has several (typically 4) switched Ethernet ports into which you canplug systems on your inside network, and/or it has an uplink port so you can add many more ports for your "LAN".

That is, if you really have a "router" (like a SMC/D-Link/LinkSys/Asante/etc.) your internal equipment should NOT be plugged into the2nd NIC on your "server", but to the switch ports on your router (or an add-on switch plugged into the router).

Your "server" should also be plugged into the router.

If all you have is really the cable "modem" supplied by your cable co., then I recommend getting a suitable router and setting up the network as dewscribed.

It can be done by plugging your LAN in one side of a "server", and your cable connection on the other side. There are a couple of ways to do this, but I find the solution too "flakey", compared to the hardware/appliance approach.

Here's an article that might help clear things up, a bit:
http://www.pcmag.com/article/0,2997,s=1482&a=4795,00.asp

This discussion is closed to new replies.