Question Locked

DVD Rewriter not recognising any discs

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, My Samsung DVD Rewriter drive has stopped recognising all types of discs, including CDs, standard DVDs etc. The drive is available in the Windows Explorer but when I insert any disc into it, it comes with error saying please insert a valid disc.

Has the drive gone dead?

Please advise.

5 replies

by hal 9000

Though you could try blasting some air through it as it's possible that the Lens has been covered by a bit of Dust or some other gunk and is preventing the Laser Head from reading anything.

Col

by pwadhwa

Do you think sucking air/dust using a vaccum cleaner will help?

by hal 9000

As every Device has some air sucked through it when the computer is being used it's possible that some dust or other junk gets in some place where it isn't wanted so if you reverse the air flow you may remove the problem.

It's also possible that the drive has just died and the Laser failed or that the Optical Head was never too great to start off with and has deterated since you got the drive to the point where it will no longer work.

Yesterday I spent time working on an Acer NB that refused to read manufactured Discs one was new fresh out of its sealed bag but would read both Recorded DVD's and CD's without a second thought. After I recorded the CD Recording software onto a Blank CD I could install the software without a problem but then the drive refused to burn a CD any more which I know it did that last time that I reloaded it but that was now nearly 2 years ago so a lot can happen in that time.

Now days I don't try to understand why it happens if I can clean out a Optical drive and it works properly great if not I replace them.

Col

by jaytmoon

Just a thought, have you recently upgraded your burning software? Nero does not wotk properly if you upgrade without completely uninstalling the previous build.
If you have not changed the buring sw latley, check the ide cable, swap it out to be sure it is not bad.

This discussion is closed to new replies.