Question Locked

e machines m 2105 laptop

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I need to open my m2105 emachines laptop to correct a broken pcimia connector (recipticle). This seems to be top secret at the e machines support site. If I cant get directions here, where might I look??
Dave

4 replies

by hal 9000

As the PCMCIA socket is part of the M'Board on every NB that I've ever pulled apart and admittedly I've never touched a E-Machines unit because they are not sold here I can not see that being any different on this unit. When you need to replace a PCMCIA Socket that means replacing the M'Board which unless you have the right equipment is not something that I recommend anyone to attempt.

Col

by davendeb

At the end of the pcimia slot is the reciever for the prongs. It is out of place and needs to be straightened up and re-attached so I may connect my card. If this is not possible, I would like to try to connect the card to its reciver and close the case, never to remove the card again. I need the case seperated to try this.

by hal 9000

Case over and removing every screw from the bottom of the case. You may also need to remove any covers and check for screws holding the 2 half's of the case together as well as any screws on the back of the unit that hold the bottom to the top.

Sometimes you have to first remove the strip between the monitor & top of the Key Board which is held in a by a couple of screws and then lift it off carefully then remove the Keyboard and then the Monitor and then split the base in half as the M'Board is fixed to the bottom half and that is what you need to get at to do this.

Col

This discussion is closed to new replies.