Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to route email from my Exchange box to our Symantec Gateway Server. I already have my firewall pointing email to the Symantec box but I need Exchange to send email out through that box as well. I know how to do in Exchange 5.5 but not in 2003. Email is going out our I-net connection but the Symantec has a different ip. So when other servers do a reverse DNS, it blocks our email because it sees it from the Inet address, not the Symantec/MX record address.
3 replies
by cg it
Your Symantec Gateway appliance MUST allow inbound port 25 traffic to pass through it as well as your firewall. Your firewall MUST foward inbound port 25 traffic to the appropriate mail server on the LAN. your authoritative DNS server for your FQDN MX record must use your public IP address for who is DNS queries on the internet, else your inbound mail wont get to you. If your having problems with recursive dns queries with other DNS servers, then your gateway/firewall is blocking inbound/outbound DNS traffic. the recursive dns queries will go outside your network to other internet dns servers.
by cg it
just a side note your LAN IP addresses have no bearing on the public side, internet side, of email getting to you. Now behind your firewall/gateway appliance is another story. The exchange server has an IP address and any inbound SMTP port 25 traffic has to be fowarded to the exchange server. Your firewall/gateway appliance has to do that.
by techkid
Your Exchange server is behaving exactly as it should, it's forwarding all outgoing traffic (including email) to its Default Gateway-- which is the firewall.
Either change the default gateway on the server to use the Symantec device (easiest) or use the Symantec device as a "smart host" and just forward the email to it.
For smart host options:
ESM>Administrative Group>ServerName>Protocols>SMTP>right click Default SMTP Virtual Server>properties>delivery tab>Advanced
Type in the IP of the Symantec device, leave "attempt direct delivery before..." blank.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
0 helpful
15 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply
0 helpful
2 replies
0 helpful
10 replies
Question Unanswered
i need help in transferring my bulk emlx files
0 helpful
0 replies