Discussion Locked

exchange drive-letters in win95b

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i dont remember anymore if i ever had the drive-letters right on my win95b-hdd. there was an ms-compatibility-problem(old question). i changed letter in config-sys from z to e. i have c(hdd), d(cd-rw-burner) as secondary master
plus e(first slave). would like to have d and e exchanged. its impossible enter/changing any letter in system/devicemanager.

maybe in config.sys(where cd-rom-driver is mentioned)i should set from E to F(last E +1), right?

then change letters. what should i set asfirst and last letter for each drive?

3 replies

by thechas

Hi Michael,

The only way I know of to re-assign hard drive letters in W9X is with this utility:

http://www.v72735.f2s.com/LetAssig/index.html

While I have not used it myself, all reports are that it works fine.

Microsoft's solution to the problem, is to set up any additional hard drives with only extended DOS partitions and logical drives.

By default, Windows assigns drive letters in a hierarchal manner.

All primary DOS partitions are assigned drive letters in the order of thedrives.
Primary Master
Primary slave
Secondary Master
Secondary slave

Then, any logical drives on the drives are assigned letters in the same manner, except that ALL logical drives from each drive are assigned letters before continuing on to the next drive.

Then, Windows assigns letters to any removable media drives.
Zip,
CD,
Memory readers.

Unless you NEED DOS mode CD drive access, I normally do NOT install the mscdex device in config.sys.
If you do install mscdex, yes, you need to match the assigned drive letter there to what letter you want your CD drive to be in Windows.

Chas

by thechas

Yes, the mscdex driver could be what is causing Windows to set your CD drive as D:

All versions of W9X use the same defaults as I described in my answer for drive letter assignments.

Check your autoexec.bat to make sure it does not also have mscdex loaded from there too.

Chas

by europanorama

i have a driver installed in config.sys since win95b didnt see cd-rom. i user universal driver.

i do not use in dos.
you think, if i will not have an entry in config.sys(the mscdex-one)anymore, and cd-rom is detected then d will be the first slave? maybe its really different in win95b, since with winme there is no problem.

This discussion is closed to new replies.