Discussion Locked

Exchange server replacement

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

Just a minute to share a problem with you. I have got an old Exchange server HW (X) that I want to get replaced with a newer HW (Y).

Well, I installed Exchange w/o problems and set it up as part of my old email system. I have also transferrd all the accounts/groups from my old server (X) to the new one (Y).

Everything worked out fine, except that when I shut down the old server (X) the complete email system slows down really bad *until* I turn the old system back on.

Any ideas will be greatly appreciated,

---
Juan Fernando Salazar
Tel (562) 337 4092

7 replies

by dlw6

Exchange servers tend to be chatty within the same site, and if server Y doesn't get an answer from server X because it's not there anymore, it may resend many times before it gives up. That only accounts for part of the problem, though.

Microsoft designers tend to think heirarchically. The server Y wants to send its MTA traffic through server X until you change some settings.

Ensure you have a connector from Y to the outside world (Internet Mail, X.400, or whatever you're using) and ensure that server Y's MTA is using that new connector. Then, remove all the connectors from server X. You moved the accounts already, and changing the connectors should remove Y's reasons to talk to X.

There may be a way to remove X from the sitehierarchy completely, but I don't have access to my books right now. Try adjusting the connectors and see how that goes first.

Good luck,
Don

by greg g. nt sys architect

Few things you should look at are:

- MX records of the server in DNS. ( Is the old server still listed as a primary server ? with the old ip address )
- If you are not going to use the old server have you moved over the exising IP address and Name to the new server.
- Route tables. Find out if the routes are specified correctly. ( route print )
- Values of the connectors: Verify the values of the x.400, site connectors and ims to see if they are the same.

Hope this helps a bit...

Greg

by mckaytech

There is a procedure you need to follow when you remove the first Exchange server from a site. By default, the first Exchange server in a site will have certain responsibilities (like re-calculating routes, hosting the off-line address book, etc.) and you need to re-assign those responsibilities before you remove it from the site.

Details can be found on Technet under article number Q152959 (www.microsoft.com/technet and search by article number).

paul

This discussion is closed to new replies.