Discussion Locked

Firewalls

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am using Windows NT 4.0 with Microsoft Proxy 2.0. I have two NICS installed with the gateway on the external NIC. Ive been told that Microsoft Proxy is too weak as a firewall. Is this correct and why? I realise that there is software out there that will enable people to hack into any system, but its been recommended to me to get another firewall using hardware. Does anyone have any recommendations? Which is better?

7 replies

by Former member

An Ethernet two-port Cisco PIX box is your best bet. Not too pricey and higly scalable.
Also provides NAT/PAT services. A great buy.

by jerrym mcse+i / a+

Hi,
recently I read an article which reviewed 6 firewalls, MS Proxy2 was listed as #3 in the final count as being a cost effective firewall, although I would point out that I don't think MS calls proxy a "firewall" most 3rd party folks see it that way. it performs the same functions as a firewall and is cost effective. one thing it doesn't easily do is realtime monitoring, but most of the others don't either, there are third party plug in's to allow better monitoring. I have used/tested proxy against many other products and prefer proxy because it is easier to configure and control and provides the same level of protection (if correctly configured) as a standard firewall,
if you have any questions reply here on email me.
Thankyou for your post!

by shanghai sam

You can Microsoft RRAS (Routing and Remote Access Service). Download it from Microsoft website. Some of it capabilities it to do Network Address Tranlation.

This discussion is closed to new replies.