Discussion Locked

flash drives - directly plugged in = USB 2.0. With hub, they're USB 1.1

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am using a Gateway MX8739 laptop, whose USB ports are v2.0. When plugging in USB flash drives into it, they are registered as v2.0.

But when plugging in an expansion hub, the same drives are registered as v1.1

Why would that be?

Thanks!

6 replies

by captbilly1eye

http://tinyurl.com/6hunv7
Is it a powered hub?
If not, that could hold your answer.
Have you tried connecting with a different cable? different port?

This thread may lead you in the right direction. Read the reply from VanguardLH:
http://tinyurl.com/697gjp

BTW...[b]For future reference:[/b] When posting a question, be sure to post it in the [u]Questions[/u] forum rather than the Discussions forum. Many do not read the Discussions forum and taking this step helps to insure that your Question gets the attention it deserves.

by w2ktechman

either that or the device is defective.

If it does not hit a certain transfer speed, it drops the speed to a 1.1 connection.

This discussion is closed to new replies.