Discussion Locked

Giving Novell 5.1 an IP Gateway Address

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm having a brain freeze. I have a Novell 5.1 file server and trying to set it to get it's time from a time server on the Internet. I have that configured correctly, however, my server can't find it's way out to the Internet. Our network is behind a NAT firewall via a DSL/Cable router.

For the life of me, I can't find where to give the server it's "default gateway" route to the outside world.

Appreciate if someone could give me a little bump in the right direction.

2 replies

by jimbb

You can type all of the commands, but it's far easier to use INETCFG. Initially this will transfer all the "LOAD landriver" and "BIND this-to-that" lines from your Autoexec.NCF to a separate file. Once that is done you can use the menus to configure everything you want in very much detail.

So, the default gateway is hidden here:
-INETCFG
-Protocols
-TCP/IP
-->LAN Static Routing "Enabled"
-->LAN Static Routing Table: The "Default Route" (You can select this) should be your default gateway.

Press Escape until you're back at the main menu, and select "Reinitialize System". Wait 1 second (not a Microsoft OS (-;) and you're set.

Jim

by lynbor

That was exactly the info I was looking for! Worked like a charm and now my novell server is synchronizing it's time with the atomic clock in Colorado! Very slick! We no longer that the annoying "time creep" problem at the server and all the workstations time is the same and accurate!

Thanks again!

This discussion is closed to new replies.