Question Locked

help Cant get the x700 ati to work

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i built this system for a friend son
i have a amd 4000 x2 64 bit cpu ,nc61s-L with Nvdia chipset mcp61 and onboard graphics.
when i put in the x700 pci-e card the screen stays blank so i turn it off pull out the card restart on onboard vid it then restarts ok and comes up with found new hardware pci ? nothing is in the pci or pci slots so it comes up with a conflict in device manager . looked in bios settings pci-e is selected as first boot but nothing happens
i read the other posts and have checked power req and thats only 300w im running 350 any ideas thanks steve

2 replies

by rob miners

350 Watts is on the low side for my likings, 500 watts or higher is a lot better. Newer
Video Cards require a fair amount of wattage around 80 watts I think.

RTFM first and make sure that you are following the right instructions for installing the card.

I would boot from the onboard video into windows and uninstall the Video Drivers.

Shut the PC down and reset the BIOS to start from the PCI-e. Shut the PC down after saving the settings. Unplug the power lead. Insert the new card and plug the monitor connector into the new card. Plug the power lead back into the PC and look at the monitor to see if it gives you any information. Newer monitors will display something like signal detected.

If the above still does not work try a better PSU.

This discussion is closed to new replies.