7 replies
by opatzg9
by ddyer
by thechas
Here is my guess as to what is going on.
I suspect that on the current system that you had to install Easy BIOS (part of the WD setup utilities) to allow that system to access large hard drives.
Or, you set up the drives with WD's utility disk, and it installed Easy BIOS or Data Lifeguard Tools for you.
With Easy BIOS, or DLGT, neither Windows or fdisk can see the formatted drive if the tools are not part of the boot sequence.
So, to see the drive on your second system, you either need to install DLGT on that system, or remove the tools an the primary system.
CAUTION: It is possible to LOOSE all data when un-installing Easy BIOS or DLGT.
Proceed with do caution!!!
Chas
by ddyer
by ctmoore1998
Boot to a DOS prompt (hold ctrl key just after poc to get boot menu and choose safe mode command prompt only. Can you change to the 'D' drive here and access the slave drive??? If not then your problem is still prewindows and you need to double check the MB to see that it supports > 8 or > 32 GB HHDs these are the 2 typical cutoff points. Also check that you don't have remode CD drivers loading and being labeled as the 'D' drive.
Check the CD-ROM drive settings in device manager Look at thedrive letter designation if possible move start letter (probably D) to a higher letter ie R and last letter can stay a Z then reboot and try again.
by ddyer
by ddyer
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending