Discussion Locked

Help on choosing equipment for 2.5 mile wireless link

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I need some help on choosing the appropriate equipment (access points, antennas, cabling etc.) in terms of features, for an outdoor wireless link.

I would prefer reliability over speed, since the link is only for carrying a 1mbit/256kbit adsl connection.

The distance is 4km (2.5 miles) and I have line of sight.
Elevation at Point A is 118m (387ft) and at point B 28m (92ft).
The antennas will be mounted on flag poles.

If you need more information from me please ask.

Thanks in advance,

Kyriacos

2 replies

by jasong224

Take a look at the Tsunami series from Proxim. We have used them for similar back-haul links and they should be more than capable of delivering the bandwidth you are talking about. They have units that operate in both the licensed and unlicensed portions of the RF spectrum. I am not sure if they still offer it, but they used to have a kit containing 2 units that basically has everything you would need for your type on installation.

Hope this helps,

Jason

by michael kassner

2.5 miles is entirely possible using 2.4MHz. There are a few things that you need to consider before you decide on equipment.

1. The Fresnel Clearance Zone is a huge factor that is typically ignored. Check out this link to make sure you have at least 80% of the zone clear or your reliability will suffer. From the link it appears that you will need approximately 30ft clear at the mid point, and that includes any physical obstruction along the path, such as trees and buildings.

http://www.terabeam.com/support/calculations/fresnel-zone.php

2. I am wondering about the flag poles and how solid they are. At that distance you will be using highly directional antennas and any deviation from optimal pointing will have an affect on signal quality.

3. This next link will give you a good idea as to the actual requirements for setting up the equipment, antenna gain and required power to create a stable connection with enough link budget or SOM to overcome any unforeseen issues. Most links require a SOM of at least 25dB for reliable service. It appears that if you use 20dBi gain antennas with minimal coaxial cable loss and run about 24dB of output power you will have an acceptable SOM.

http://www.terabeam.com/support/calculations/som.php

4. A real concern is what will be encountered by the RF signal along the path, I already mentioned the physical obstacles, but you also need to consider RF interference or other RF links that maybe in your vicinity. It is a good first step to at least check for RF along the link path.

5. As for equipment the best situation would be to have a combination unit, where the antenna and radio are in one enclosure. This device is PoE enabled, only needing a Cat5/6 cable running to it. This reduces any coaxial cable loss to a minimum, and provides good weather exposure protection. The Tsunami mentioned by Jason is one good example of this type of equipment. Cisco and others also have similar devices, it is just a matter of your personal taste and budget.

This discussion is closed to new replies.