Question Locked

How can I find the IP address of a router 2 years old

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a D-Link DI-1137 router, which was used in one of our firms other two offices, these offices closed, and so now has been sat on a shelf gathering dust. I have done the following:

1) pinged the possible IP address's, of 10.0.94.200 or 94.250, 10.0.95.200 or 95.250
2) connected it via a small powered switch to the laptop
3) set the laptop IP address to 10.0.95.201, and the same subnet mask.
4) ran "Advanced IP Scanner v1.5 from www.radmin.com" on the laptop, and scanned the range of 10.0.0.0 to 10.0.255.255, no response has been detected by the app from the router.

I have got no ping backs at all, I dont know what to do, and I desperately need to get this router up and running.

Has anyone any suggestions?

Thanks

James

9 replies

by seanferd

Reset the router, and use the default IP that this router uses? (Either find your manual or download a copy, it certainly will come in handy.)

"pinged the possible IP address's,"

You've only covered one group in the private address space.

I would seriously consider 192.168.0.1 as the most obvious possibility.

by oldbaritone

Since you describe the router as "has been sat on a shelf gathering dust" you really don't need any of the information in it.

Just do a hard reset and load the factory defaults. If you don't know how, it's in the manual. After you do that, everything else explained in the manual will match too.

Here's a link to a page with D-link manuals:
http://www.retrevo.com/samples/D-link-Router-manuals.html

Not your exact one, but you can dig a little and find it, or see if the 1135 is close enough.

and here's a link to how to do it
http://www.ehow.com/how_2091714_set-up-dlink-wireless-router.html

by ron k.

I haven't had enough coffee to totally understand the question.
I believe I'll take a nap now.

by dmambo

If for some reason you don't want to reset it to defaults and reconfigure it, then setup your PC to get it's address from DHCP and run ipconfig /all from the command prompt. This will list the gateway. Enter that address into your browser and you should be able administer the router. It looks to me that the router's not in the 10.0.94(or 95.0 subnet.

by jcroll

Hi Guys, most of the obvious I have tried, I am currently running an IP scanner around the clock on it, but am concerned my laptops IP/Subnet wont match and therefore, it will ping the correct IP address and not get a reply. I have looked for the 1137's manual but could not find it, so therefore dont know how to perform a full reset. The router was set outside of DHCP, so that wont work either unfortunately, I will try and find the manual again, but I am not holding out much hope for this!

Any further words of wisdom?

by seanferd

Press in the little button. (OK, maybe don't.)

After a bit of net-fu, I got you this:
ftp://ftp.dlink.co.uk/isdn_lease_line_routers/di1137/

Poke around in that directory. And yeah, they apparently "disappeared" this model from all the dlink sites. I've seen it happen before...

P.S. Have fun - this isn't a regular router. And you'll have to telnet in.

P.P.S. You may just have an account with dlink for this, ring them with the serial number and find out.

by ron k.

Your reply is pretty much everything that I edited out.

This discussion is closed to new replies.