Question Locked

How can I install XP from network?

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a laptop that doesn't have cd rom and I need to install XP on it, how can I do this from network?. It doesn't have anything installed.. even DOS.

2 replies

by grassiap

well might be a tricky one depending on several factors.

1/ does you laptop have a floppy to boot on ? if yes make a dos boot floppy with network installed then connect to a network share where your i386 is present and run the install.

2/ is your laptop able to boot on USB pendrive ? if yes you're in a similar situation as the above. You'll need to "format" your usb drive to make it bootable (there is a tool from HP to do that there are articles about it in tech republic forums)

3/ is your laptop remote boot or PXE capable ? if yes you'll have to connect it on a network where you have a DHCP/TFTP server available, it will feed your laptop with a floppy image file similar to case 1/
if you have access to a win2000+ server you also can use the RIS service but that's quite overkill just for one install

4/ if none of the above applies you'll be able to boot from a PCMCIA (or rather PC Card) memory card (check with sandisk.com) and you are in case 1/ on your PCMCIA "drive"

5/ if not even that is possible, then have a local techie remove the HDD from the laptop and move it to another laptop (or a desktop with relevant cable adapters) and perform a "standard" CD install, shutdown the box when you get the red line announcing that the PC will reboot in a few seconds, replace the HDD in the original laptop and proceed.

to check whether your laptop is USB/network/PCMCIA boot capable enter the BIOS at boot up time (F2 or Del key is the most common) then look for a page with a list of boot devices and boot order
if unsure move the option you'll want to try on top of the boot order.

as for the boot floppy or image : check on
http://www.bootdisk.com
if you'll go for a remote boot install and your other end of the network install is a windows box the simplest stuff is :
http://tftpd32.jounin.net/

the whole process is clearly explained in each site (creating the boot floppy, or setting up the DHCP/TFTP server) so I'll not redo it all over again.

if you have trouble putting it together feel free to contact me by email.

Hoping this Helps.

Philippe

This discussion is closed to new replies.