How do I use an Emergency Repair Disk?
Can someone share some instructions on how to use an ERD to boot-up and repair Windows 200 installation?
I reboot with the floppy in the drive, the computer boots into dos mode in the A:\ drive, Then what??
Windows Forum
Can someone share some instructions on how to use an ERD to boot-up and repair Windows 200 installation?
I reboot with the floppy in the drive, the computer boots into dos mode in the A:\ drive, Then what??
by dc1
by dkstanford
by alpha-male
This should help:
http://is-it-true.org/nt/nt2000/atips/atips32.shtml
Delete any spaces in the URLs. Good luck!!!
by dkstanford
by jimmy
First of all if you are putting in a disk and gettin to the A/:. prompt i assume it is a windows95 0r 98 boot boot disk you are using.
This is no good for a repair only for a re-install.
_________________________________________________
What you want to do is:
1- You will need to have your PC set to boot from CD Rom in the first instance, otherwise it will simply load the old version of windows from the C:/
Try putting the windows 2000 disk in the CD Rom drive and starting the PC and seeif it boots from the CD Rom. If it does you will immediatley be greated by a blue screen laoding all sorts of files etc. Simply follow the instructions to repair.
If it doesn't and goes straight into Windows you need to enter the BIOS of the PC andset the PC to boot from CD ROm.
In this case what you would do is
2- Start the PC and you should see a message saying press***** to enter setup.
The stars above simly indicate whicever key you need to press in order to enter the setup (BIOS) of your PC, normally F2 or Delete key.
To do this press either of the keys to enter the PC BIOS or setup.
Now you should see something which says BOOT sequence.
look at the bottom of the screen for how to change the options.
Change boot sequence to CD Rom first and then follow the instructions for task 1.
Once you have repaired the operating system you want to change the system to boot from A:. again.
You would do this again by entering the BIOS and changing the field back to boot sequence first boot a:/
Hope this helps
by dkstanford
by cul8rm8e
Good Tip!
after you sort this out you want to install the command console so that you dont have to use the CD to boot from in the future to do a repair or...
all you have to do is insert the Win2k CD,go to start,run and type in there D:\i386\wint32 /cmdcons
using (D)if this is your drive letter for you CD-rom drive.
by dkstanford
by dkstanford
This discussion is closed to new replies.
Sort by Trending