8 replies
by fafdsfs Accepted solution
by rob miners Accepted solution
Clean the Cooling Vents
Depending on the model, vents can be found on the side, back, and/or bottom of the notebook PC. These vents allow air to flow through the PC and keep it cool. Buildup inside these vents impedes the cooling process.
Clean I/O Ports
The back of the notebook PC has a series of ports. After cleaning the cooling vents, take the compressed air and blow out any debris that may have accumulated in and around these ports.
Without dismantling the notebook you are limited as to what you can do.
by cg it Accepted solution
by rob miners Accepted solution
by cg it Accepted solution
by rob miners Accepted solution
by 1bn0 Accepted solution
Just schecked the maintenance manual. Here: http://h10032.www1.hp.com/ctg/Manual/c01295898.pdf
Same setup as a nc6000 I recently pulled apart
The fan sucks air up through the intake in the bottom, spins it around and then attempts to blow it through the heat sink cooling fins and out the back.
The nc6000 had fine dust like cement powder completely blocking the fins. Used a thin paper clip to dislodge the dirt. I still had to take the machine apart to remove the dust bunny made of cat hair stuck between the fan and the cooling fins. Compressed air won't remove it.
The machine kept shutting down after 2 to 3 minutes from the heat build-up. Keep it up long enough and it can ruin the processor.
After I removed all the cat hair and other crap, I reassembled the machine and it now works great.
by oh smeg Accepted solution
Like the one shown here
http://www.antec.com/Believe_it/product.php?id=NzI=
These have fans in them and suck the air away from under the NB and because of the higher speed airflow suck any air borne dust and other crud away from the Air Intake of the NB. The NB will run cooler and last a lot longer with one of these things under it and plugged into a USB port. ;)
Col
This discussion is closed to new replies.
Trending Laptops Forum posts
Sort by Trending