Discussion Locked

How to connect to Domain with 2 NIC's

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have Windows NT4.0 with SErvice pack 6 with two nic ( 2 ethernet cards ) both joining different classes of ip.

My problem when I activate both NIC cards I am unbale to join the Domain but when i activate one network which connects to Domain it does connect .

What could be the problem.

3 replies

by curlergirl

Here are a few suggestions:

1. Make sure that only one NIC card has a default gateway assigned. This would probably be the one on the domain side, but you haven't given a lot of detail, so I can't be sure.
2. Use static routes to do any other routing that is required.
3. Make sure that you are using the DNS servers that are on the domain side also.

Hope this helps!

by joshg

Check the binding of the services to the NIC's. DNS and DHCP and other services are probably running on a specific IP subnet.

This discussion is closed to new replies.