Discussion Locked

How to delet all info on a new hd

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
installed a new wd 160gig hd ide drive as a single, system os is win2k pro, used wd instalation disk that set up a ddo and installed the os updated it and turned the system off for the evening. When i booted the system it would not boot and received this error. windows 2000 could not start because of a computer disk hardware configuration problem. could not read from the selected boot disk. check boot path and disk hardware. WD claims that they can't help as it is a software conflict great some support they offer. I have tried the rc and bootfix no help, booted with a win98 and used fdisk that allowed me to re-install the os but still get the same error. I would like to erase everything on this new drive and begin from scratch. One thing is to upgrade the bios but having difficulty doing that. Can I set up the new drive as a slave and using what program to erase everything including the ddo from the new drive, and remove any and all partitions.

2 replies

by thechas

Boot from your W98 boot disk again.

At the DOS prompt, run fdisk and delete ALL logical drives and partitions.

Re-boot and run fdisk /mbr

The drive will be as blank as it needs to be.

Now for some problems / issues:

The newest version of fdisk for W98 CANNOT setup drives larger than 137GB.

For Windows 2000, you need service pack 3 to be able to deal with a drive larger than 137GB.

What to do?

Download the Windows XP startup disk set for XP Pro with service pack 1.
(Or, create a MS-DOS boot disk on an XP PC with SP1 installed.)

Create the disk set.

Boot from the XP disk set, and partition the drive as desired.

Now, boot from the W2K CD and install Windows 2000.

You might also try the assorted alternate boot disks linked at www.bootdisk.com

Also, www.madboot.com
http://www.ultimatebootcd.com/

You may need to use a smaller drive as your boot drive with Windows on it. Then, after upgrading to SP3, install the 160GB and use it as your application programs and data drive.

If your motherboard does not recognize the full capacity of the 160GB hard drive, your options are to:
1. Use the WD utility
2. Install a PCI IDE controller card.
I recommend the PCI IDE card as that will give you 2 more IDE channels and take care of most of your problems with the drive.

Chas

by haritom

Connect the harddisk as slave to a different system, which has latest service pack and erase the contents or format using disk management option.

This discussion is closed to new replies.