Discussion Locked

How to find a NIC w/Mac Address only

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am looking for a command or utility to search & find a NIC or Jet direct by the Mac address only. W/O an IP address. It shut down my JetDirect on a HP 4500. The error sheet gave me the MAC address that caused the error. The only way I fixed it wasgiving a new IP address. We run Novell 4.11 w/Win95 clients w/IPX-SPX & TCP/IP.

Thanks for Help

7 replies

by mckaytech

You can find out who made the device from the first 6 digits of the MAC address (look it up at http://standards.ieee.org) and that will help you narrow it down some.

Then you can go to a DOS prompt and type "arp -a" and see if that MAC address isin your current ARP cache - if so, you'll see the IP address associated with it.

If it's another JetDirect card (very likely) I believe that JetAdmin will list by MAC addresses.

Otherwise, a packet trace is your best bet.
Hope this gives you some ideas to start with...

paul

by tbv

You have Netware. Use the userlist command with a /A switch. It will show you all connections to the server including the MAC address of each connection and who/what is using the connection. Syntax of command is Userlist /A

by dbowlin

Doesn't the JetDirect card give you the option of a BOOTP IP assignment upon start up? If you configure it to get the IP on boot up you may save yourself some headaches.

Also, check your switches/hubs. Many of them are coming with software thatwill tell you this info. I use HP ProCurve switches, and there is a section where I can see the MAC address

Good luck.
Dan

This discussion is closed to new replies.