Discussion Locked

how to load windows 98 over XP

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I lost every thing on my PC running XP .I may have a scratched disc because after using the 6 boot discs I miss files through out the XP install.I tried loading ME but I ran into a problem with the bit about partitions.I currently have neither installed.The hard drive has been formatted.I would like to know how to load ME

2 replies

by oz_media

You need a generic DOS boot disk, you can find one at bootdisk.com. A win98disk has all the correct start up files if you can see an ME boot.

Create the floppy boot disk and start the computer with it in the drive.

After it installs the Win startup files you will get a DOS message to get help and a flashing a:\ prompt. Insert your operating system CD in the CDROM (Drive letter will be changed for the help partition, if D USED to be the CDROM, you will need to type E:\ followed by SETUP) this drive letter change is temporary.

If old CDROM was D:\ just type 'E:\setup' (without quotes) and press enter. This should just start the Windows setup from disk.

If this is not an OEM computer, it is a good idea to have you graphics, sound and NIC drivers ready when setyp is finished.

So if it was

by dmiles

Start w/Windows98 startup disk and boot computer
If Win ME is the full version and not an upgrade you will be given choice to run setup with cd-rom support,select and proceed

If your disk still has XP partition installed use the Fdisk utility and wipe the drive clean,partition and format the drive,then you can proceed to setup

This discussion is closed to new replies.