Discussion Locked

How to make transformer

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I would like you to say the material needed and the step to follow in making it, even with driagram.Thank you.

3 replies

by thechas

You need advanced electronics knowledge to design and fabricate a transformer.

The type of transformer determines what type of core you need.

The maximum voltages determine the type of insulation and isolation required.

Then, you need to calculate a turns ratio to allow for the desired output voltage and current.

After you know how much wire you need, you can determine the minimum size of the bobbins.

It is MUCH cheaper to search surplus electronics sites for the actual transformer you need.

One I like is www.hosfelt.com

Chas

by thechas

For AC Power Transformers:
SAFETY SAFETY SAFETY

You need to perform calculations to determine how hot the transformer will get under various load conditions. Many power transformers have internal fuses that open the primary circuit if the transformer gets too hot.

You also need to account for line voltage isolation.
In the US, every transformer is tested at a minimum of 2 times maximum line voltage plus 1000 volts for insulation breakdown.

Chas

by nikki_pay

first, you must choose the best kind of materials to be use, the materials to be use are, e and i core, wires for the primary ang secondary winding, the cotton tape for the insulator, and the input voltage or the source voltage.

This discussion is closed to new replies.