8 replies
by rebelleader Accepted solution
by robo_dev Accepted solution
My thought would be to extract the patch and see if it's just a 'one or two DLL' patch or something really messy
Supported Security Update Installation Switches
Switch Description
/extract[:path] Extracts files without starting the Setup program
http://www.microsoft.com/technet/security/bulletin/ms05-017.mspx
by rebelleader Accepted solution
Looking at the contents of the extracted update, there are 8 .DLLs and 1 .SYS file that look like they apply to my issue.
I guess I can try to put these files into their proper locations, register them and see if the issue is corrected.
I am going to have to do a fair amount of QA testing on my test equipment to be certain that this does not break anything.
Thank you for the quick response.
by rebelleader Accepted solution
by rumseycw Accepted solution
MSMQ vulnerability has been addressed in XP SP2 and XP SP3. The patch was for XP SP1 and below.
You can now update to the latest Service Pack (SP3) using SUS or SMS. Please see technet page http://www.microsoft.com/technet/security/bulletin/ms05-017.mspx
by rebelleader Accepted solution
by oh smeg Accepted solution
I would ignore it for the time being and ask M$ Directly on your Usual Channel Account as to what to make of this Message/Report.
Col
by rebelleader Accepted solution
I thought that might be the case as well. To test I turned off the MSMQ service and ran my test again. The machine tested clean. When I turned the service back on and ran the test, the vulnerability was back. The problem looks to really be present.
I do not have the luxury to ignore it as this flaw will cause me to fail a security audit that I am going to be going through in the next few months. I will contact Microsoft to discuss this problem, but am still open to any other suggestions from the community.
Thank you again for assisting.
This discussion is closed to new replies.
Trending Security posts
Sort by Trending