Discussion Locked

How too Setup a Wireless Broadband LAN

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello
Need some assistance in seting up a wirelss broadband network for use at home only. Just need to know what i would need and and configuration advice and what problems would i encounter at home ?
Thanks

5 replies

by sgt_shultz

assuming dsl. you need wireless dsl modem/router. you need compatible wireless client card in all the pcs. you follow the instructions that came with the hardware and you are good to go. read up lots of nice little whitepapers at www.linksys.com
linksys stuff is flakey/quirky if you ask me. but it is all i've used actually. you must have line of sight. you can't necessarily get signal thru walls and floors. might. if you need that you can reflect it some. goes thru windows. i have done building to building 500ft thru windows each end with linksys wap11's (i don't think i am remembering model number right).in bridge mode. the security stuff. once your system is all set up and working, change the name of the wireless network from the default, change the admin name and password, set up so only MAC addresees of your computers can access, enable WEP, disble 'broadcast my network name'.

by thechas

I would go with Linksys or perhaps Netgear equipment.

Make sure that you start out with ALL equipment from the same manufacture. This is just to prevent any blame issues should you have problems and need to contact tech support.

Beyond what Sgt_Shultz gave you, pay close attention to the SECURITY settings on the client PCs and the wireless hub / router.

I recommend installing a firewall on each client PC. This will provide an extra measure of protection should someone hack into your network.

There are some good tutorials at www.wown.com
Linksys also has some good pages on network configuration.

Chas

This discussion is closed to new replies.