18 replies
by carlos.nino
by dbrown
We reinstalled the printer and it didn't work.
by dbrown
by dbrown
by shawn
by dbrown
We upgraded the print server (a couple months ago)while it was in NT. We recently upgraded the server to w2k server. I have had the user deinstall and reinstall the printers with no luck.
by rcom
The "N" at the end of the printer's name stands for network so why is it connected through a Server? Are you using a parallel cable? It should be connected directly through the LAN using the built in nic.
Other than tracking printer useage I don't see why your not using this feature. The oldtime print server is no longer needed.
If the printer's IP settings match the rest of the LAN it will show up like a workstation. You may need to allow it through the firewall.
The LAN settings can be modified through the printers buttons. Or you can use HP newer version of Jet Direct software. If you're using DHCP change to that or give it an IP address and set up the gateway and DNS.
This will be way faster.
After setting it up go to the N-hood on the workstations, right click on the printers icon and select install. This quick and easy task can be performed by your users.
by dbrown
by nospam
by dbrown
by tyrone
by dbrown
by dbrown
by dbrown
by dbrown
by rcom
There's no issue with the drivers. The drivers are ready to install from the Server.
On the Server open the printer Properties.
On the Sharing tab, click Additional Drivers.
Choose the operating systems of the client computers. Users on client computers can connect to the print server and automatically download the same drivers.
From the workstations go to the network n-hood and find the shared printer. Right click and select install.
Are you using the LPT ports or the LAN to the server. I'll assume since you have more than one printer that you have something like a jet direct box or the printers are connected directly to the switch/hub.
Windows 2000 will automatically configure the printer to use SMP (Standard Port Monitor) instead of LPR. This uses SNMP (port 9100) then picks a random port somewhere about 1030 to communicate. This may be causing a problem if the an LPR driver is running on the Server or if the firewall is constantly checking each time a packet comes across. To test disable the firewall and see if there's a difference.
If it is a jet direct box then I'd suggest getting the latest firmware.
If you don't have more than one of the same types of printers attached to the Server disable printer pooling.
by dbrown
by dbrown
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending