Discussion Locked

HP 6250 SCSI scanner and NT

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an HP SCSI scanner on a NT Compaq station with Compaq Netelligent net card.

Do you know/did you heard of any reported problems when using HP SCSI scanners under NT? I tried with SP 4 and SP 5 installed, separately. When installing the dedicated software, it keeps returning a message: Error communicating with the scanner. Compaq and HP support teams have no answers.

No other special software and/or hardware installed (Office 97, Matrox Millenium video drivers only and SP kit v.4 or v.5).

BIOS disabled IRQ for video, disabled LPT and COM ports, internal modem installed).

Thanks

7 replies

by bryan_hartman

Try checking the scsi id on the scanner. I believe on the 6250 you do this by opening the lid to the scanner and find the green light then push the green button on the front of the scanner after a couple of seconds it will start to blink. Count the number of times it blinks that is your scsi id. Make sure its not the same id as your scsi card. If you have to change the id push the green button on the front and hold it in it will start to blink after it blinks the number of times you want your id to be let go of the green button. Also go into the control panel on the computer to the scsi icon and make sure that the scsi card you are using is listed and that the scanner is listed under that. If the scsi card is not listed reinstall the drivers for the scsi card. if these settings are correct the scanner should work. what kind of scsi card are you using? there could be updates for that.

by cd

1. SCSI ID scanner different from SCSI card
2. SCSI drivers updated

3. DO NOT WANT TO INVEST ANYMORE TIME IN SEARCHING FOR AN ANSWER.
SOLUTION:

I HAVE CHANGED THE SCANNER FOR AN EPSON SCSI SU OFFICE.
Initialization time under 2 secs, scans up to 7 secs/full collor page.
Almost heavenly in technology.

by k.c.morgam

Make sure NT can see the scanner and SCSI card. look in control panel/scsi adapters. Do you see your card there? If yu do look at the drivers tab, is there a driver loaded and is it started? Back to the Devices tab, click on the + next to the scsi adapter, you should see the scanner there, if not you have a scsi problem not a software problem.

by cd

SCSI card recognized
SCSI card works fine on another NT system or WIN98 system

DO NOT WANT TO INVEST ANYMORE TIME IN SEARCHING FOR AN ANSWER.
SOLUTION:

I HAVE CHANGED THE SCANNER FOR AN EPSON SCSI SU OFFICE.
Initialization time under 2 secs, scans up to 7 secs/full collor page.
Almost heavenly in technology

by beyenika

Make sure you are logged on to your workstation as administrator prior to installing your scanner. After installation, add yourself in the local admin group and see if it works.
GOOD LUCK.

by cd

Already did this.

DO NOT WANT TO INVEST ANYMORE TIME IN SEARCHING FOR AN ANSWER.
SOLUTION:

I HAVE CHANGED THE SCANNER FOR AN EPSON SCSI SU OFFICE.
Initialization time under 2 secs, scans up to 7 secs/full collor page.
Almost heavenly in technology

This discussion is closed to new replies.