Question Locked

HP 932 Printer Problem

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My HP 932C printer started blinking as it aleays does when it runs out of ink. I replaced the cartridges but it continues to blink. Thinking maybe the cartridges were bad I replaced them again to no avail. I have cleaned all contact points, rebooted, reinstalled software but nothing helps. Is my printer scrap or is there some fix?

6 replies

by nepenthe0

http://tinyurl.com/3jlar4

Page 40 of the manual has a discussion of the flashing light codes.

Please post back in this thread if this doesn't clear things up for you.

Rick/Portland, OR

by oh smeg

HP Printers have an expiry Date built into the Ink Cartridges which stops the printer working after that date is passed.

That could be the problem.

Col

by tech450

I bought 2 different sets of cartridges and both were fresh out of the box but I couldn't find any dates on them.

by oh smeg

As HP use the same cartridge over many models you may have got some for a model without the Computer Chip requirement in the Cartridge or the maker may have mispackaged them

If they are Genuine HP Cartridges they may have been sitting on the shelf for too long and have expired or be for a different model Printer with out the need for the Chip. All HP Cartridges that require a Chip Interface on the printer have a [b]Best Before Date[/b] on them well here at least and it's been that way for at least the past 3 years if not longer.

Col

by nimmo

Printers have small sensors most of the time made out of plastic, therefore the can be pretty fragile.

They are placed within the printer in different locations to allow you to be informed of any problems that may occur.

There is a sensor inside the area where the toner goes that sensors if the cartridge is inserted or not. If this is broken or stuck you will get a constant flashing light/error message.

This discussion is closed to new replies.