Question Locked

Hp Cpmpaq nx6110, wont start just dead ! !

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi! this is my first question, im looking to see if anyone would have a reason as to why my Hp Cpmpaq nx6110 wont start (or do anything) When i plug in the AC the power light on the front flickers, however when i try to power up nothing atall happens not even the fan or any beebs ? anyones thoughts would be grateful!
Thanks in advance

5 replies

by balge

hi
only time Ive seen this was a shorted out motherboard.
hopefully something less serious for you - test the PSU if you have testing gear or try a substitute? make sure the ATX power lead is plugged into the board properly. is the wall socket/plugs/cable good ?
cheers

by the scummy one

and unplug the unit. Wait a minute or 2. Plug in the unit without the battery. Does it start to boot?
If so, power it off, replace the battery, and try again. Does it boot?
If so, you are fixed, if not, replace the battery. Also try this site as there is a recall for some HP batteries, including some for the nx6110.
http://bpr.hpordercenter.com/sbpr/

by dazeboy79

have you tried booting in safe mode?

have you tried replacing the battery/Power supply?

could also be hard drive or mobo

Id try the HP support forums and/or call tech support, that is afterall what you paid the big $$$ for...
http://h20000.www2.hp.com/bizsupport/TechSupport/SupportTaskIndex.jsp?lang=en&cc=us&taskId=110&prodTypeId=321957&prodSeriesId=449877

OR

just google around a bit and see if you can just start eliminating possible causes one by one

http://www.daniweb.com/forums/thread96480.html

This discussion is closed to new replies.