Question Locked

HP f2105 no signal input

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi. My computer monitor, HP f2105, has recently decided to go on strike. I am getting the no signal input message. I have tried turning it on and off, unplugging it, waiting 5 seconds and turning it back on, nothing works. I'm not sure I could take this computer apart and check things out but I am willing to try some simple things if someone wold be so kind as to pass along a few helpful hints.
Thanks to anyone who answers me. :)
Lisa

3 replies

by oh smeg

To the Monitor at the Computer end. This involved undoing 2 screws maybe if they where tightened up when the lead was first fitted tot he computer. It's also totally possible that if these 2 thumb screws where not tightened up when th monitor was first plugged into the computer that the lead has pulled out of the socket and is no longer making a connection. It only needs to be out a little bit for this to happen.

If the lead is correctly plugged in remove it from the computer and look at the 3 Rows of Pins for any missing or bent pins. If all appears to be right plug it back into the computer please note that they are polarized devices that can only be plugged in one way. If it doesn't go in easily do not force it try turning the plug over through 180 Degrees and plugging it in again.

If you have another computer available try plugging the monitor into it and see if it works now. If it does the Problem is in the computer and if it doesn't the problem is the actual monitor.

As HP do not have a Service Manual for this unit I would suggest first reading the Owners Manual and go through their Trouble Shooting Procedures. If that doesn't work you really need to return this to a Authorized HP Service Agent for Repairs/

Col

by thumbsup2

First, make sure the signal cable hasn't come loose from the back of the computer or the monitor. Strange things happen when people clean! ;)

Assuming the signal cable is secure on both ends, unplug the monitor's electrical cord from the wall/power strip (whatever you're using), press and hold the power button on the monitor down for at least 10 seconds and then, while still holding the power button in, plug the monitor back in. This is supposed to reset the monitor, so turn the computer on and see if there's a signal.

If there's still no signal, take the monitor to another computer and test it. If it doesn't work, you know the monitor is bad. If it does work on another computer, we're going to have to suspect the graphics card in the computer itself.

Do those tests first, then report back here. We'll know which direction to go based on what you find.

.

This discussion is closed to new replies.