Discussion Locked

I am trying to create a Image disaster recovery solution using ghost.

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to create a Image disaster recovery solution using ghost.
I have a Dell 2950 Poweredge Raid 5. Perc 5/i Raid Controller.
I am using norton ghost enterprise solutions suite 2.0. (ghost 11.0)
I want to create a base image of my Domain Controller and file server.
Scenario: Server goes down and I am unable to load the OS.
Capability: I want to be able to Image the Server, to get it up and running.
Problem: I need to know if there is a dos version of perc 5/1 driver or a dos aspi driver that I can include in the norton bootdisk.
Or is this even necasssary? From dos will norton ghost see the virtual (logical) drive or will it see the actual physical disks?

Ghost and hardware-level RAID systems
Although it is not a supported feature, Ghost can sometimes create and restore images to hardware level RAID systems if you load the appropriate DOS ASPI driver to support this. Load the DOS ASPI driver when you create the image file and again when you restore the image file. DOS ASPI drivers can usually be obtained from the RAID hardware manufacturer. For other ASPI driver information, see the document Information on ASPI drivers.

This is from the Symantec Knowledge Base.

http://service1.symantec.com/SUPPORT/on-technology.nsf/docid/1999010613522725

Thanks for any help!!!

1 reply

by p.j.hutchison

From experience, you do not normally need aspi drivers to view disks or volumes on the server as long as the RAID is already set up on the disks, Ghost will see the disk as a normal volume.

Note, do not use Windows Dynamic disks if you need to image them, use Basic disks wherever possible, otherwise Ghost cannot image them.

This discussion is closed to new replies.