Discussion Locked

ICS Problems

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We just installed a new server running Win2k Server. The Win98 2nd Edition
workstation that is sharing their internet connection, now gets an error
message that ICS can be installed on one computer. When we disable ICS on
the server, that user cannot log on. We will have to rewire the phone if we
put the modem in the server. Any ideas on what is going on?

TIA

Wes Purvis

3 replies

by mckaytech

The "only one ICS" message makes sense. I can't quite put my finger on the most likely cause for the logon failure, but my best guess is that the network card on the ICS workstation that goes to the local network receives its IP address from the Server ICS. When you disable the Server ICS, it then doesn't have an IP address.

To start to troubleshoot this, it would be helpful to know what IPCONFIG /ALL shows on the workstation when the server ICS is disabled and when it is enabled. If thereis an IP when the server ICS is disabled, the next step would be to see if you can ping the server from the workstation.

I think you're better off using a workstation for Internet sharing (just an opinion and others may differ). After doing the diagnostics above, I would disable the ICS on the server and concentrate on the ICS configuration on the workstation because I think that is where you will find the problem.

Hope this helps you get started....

paul

by wes purvis

We tried checking the IP addresses and there were no conflicts. We then removed the TCP/IP and ICS from networking on the workstation and reinstalling them. Still no luck. Thanks for the suggestion and hopefully we'll find a solution.

This discussion is closed to new replies.