Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I get a stack fault when I logon as a normal user within Shlwapi.dll. It's not the win386.swp file and a reinstallation doesn't help either. Any ideas ?
5 replies
by saihib
Check the attributes of your win386.swp file. Make sure it is not set to "read only."
The question was auto-closed by TechRepublic
by philthegreat
CAUSE
=====
This behavior can occur if the Win386.swp file located in the Windows folder has
its file attributes set to read only. Windows uses the Win386.swp file to create
virtual memory.
RESOLUTION
==========
To resolve this issue:
1. Click Start, point to Find, and then click "Files or Folders".
2. In the Named box, type "win386.swp" (without the quotation marks).
3. In the "Look in" box, click Drive C, and then click Find Now.
4. Right-click the Win386.swp file, click Properties, and then click to clear
the "Read-only" check box.
5. Click Apply, and then click Close.
The question was auto-closed by TechRepublic
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
0 helpful
15 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply
0 helpful
2 replies
0 helpful
10 replies
Question Unanswered
i need help in transferring my bulk emlx files
0 helpful
0 replies