Discussion Locked

INSTALL SOFTWARE ON NT

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I install A new HP CD-WRITER on NT workstation, during installing a driver (almost finish) its freeze up on me, so i have to power it down and restart it, log back in and try to reinstall the driver and software again, but this time it't won't execute it, no matter how many time i click on SETUP icon it just won't execute it. I did try to remove the progame on add/remove programe but it wont let me remove it ether.
What can i do to make it executable on CD-w with out copy all data to temp folder in hard drive and install from there? is it somethings to do with registry? Please help...

11 replies

by rfinley

When you learn to type clearly where I can read your question, and be sure of what you are asking, I will respond to your question.

by dmiles

The driver is apperently not an NT device driver check the hardware compatibility list to see if there is a nt driver to download.the one you are installing will not execute,because it is not present on the system.If you open the registry and look at HKEY_LOCAL_MACHINE\Software
Deleting the key will not help in deleting the software from system
Donot take some of these comments personal.

by donq

I have both a read only and a read/write CD by "disc" on an NT Workststion machine. I would guess you need to reload NT Workststion and/or get a different HP installation CD? It sounds as though you are having a software problem?

by aenezi

Hey I?ve faced this problem before and to fix it you need to look for the latest driver of your CD Writer in HP home page because they keeping update the drivers. but you need to clean the old installation. Just bring Boot DOS disk and log in to
c:\winnt\system32\drivers and u will see two extra files has been added to you driver files.. rename them and install the update driver of your tool. it will work

Al-Enezi

by aenezi

Hey I?ve faced this problem before and to fix it you need to look for the latest driver of your CD Writer in HP home page because they keeping update the drivers. but you need to clean the old installation. Just bring Boot DOS disk and log in to
c:\winnt\system32\drivers and u will see two extra files has been added to you driver files.. rename them and install the update driver of your tool. it will work

Al-Enezi

This discussion is closed to new replies.