Discussion Locked

Installing the first domain server

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Instructions say that to install the first domain server during setup check no this computer is not on a network ... and then blank the workgroup name. Doing this causes the "next" button to go gray (unavailable). How do you install the first domain server?

3 replies

by zinnix

Hi.

The only way to "upgrade" win2k or "downgrade" win2k
to/from Domain Controller, is by using
"dcpromo" command.
So in your case, you should finish the installation, by choosing "workgroup".
Later, issue the command DCPROMO,
and answer "yes" to the question regarding to:
"is this the first dc in the forest".

Good Luck.

by rdhaar

I think it would have helped as I didn't know this. However, it turns out that what was needed was to do the installation with the server attached to a network hub. then everything worked perfectly.

This discussion is closed to new replies.